ZERO CNC TRIP GROUP FOR M24 GEN.2 AIRSOFT PRO (AiP-5840)
Not available
Insert quantity
Fast shipping
Secure Payments
Certified transaction
Original products
The durable and reliable trigger mechanism is the basic premise for a successfully upgraded sniper rifle. The trigger mechanism provided is sufficient for the basic springs. But when you use stronger springs, it significantly increases the chance of damage. Unfortunately, this cannot be avoided even with cheap alloy triggers. Only the steel mechanism can guarantee maximum durability.
AirsoftPro CNC trigger mechanism uses a proven design used for the other models. The goal was to create a very robust trigger mechanism that would not fail even when using the strongest springs. Therefore, it is manufactured with a combination of aluminum alloy parts and hardened steel
Body CNC machined from lightweight, yet strong 6061-T6 aluminum alloy.
Aluminum parts with high quality anodized finish.
The piston stop, lever and spring guide stop are made of hardened steel to HRC48-55.
The upper part of the trigger is equipped with a ball bearing for a softer press.
The axis is made of stainless steel.
Two torsional spring safety returns lock in the original position.
The whole trigger consists of 20 parts. Tested on springs up to M190.
All spare parts available.
Easy to install in less than two minutes.
Allow the use of the stock safety lever.
The complete set is designed and assembled in the Czech Republic. Partial technical solutions are protected by copyright!
This high quality trigger set fits SW (Snow Wolf) M24 and also CYMA M24 (CM.702). You can use it for stock or for any custom upgrade piston and cylinder.
AirsoftPro CNC trigger mechanism uses a proven design used for the other models. The goal was to create a very robust trigger mechanism that would not fail even when using the strongest springs. Therefore, it is manufactured with a combination of aluminum alloy parts and hardened steel
Body CNC machined from lightweight, yet strong 6061-T6 aluminum alloy.
Aluminum parts with high quality anodized finish.
The piston stop, lever and spring guide stop are made of hardened steel to HRC48-55.
The upper part of the trigger is equipped with a ball bearing for a softer press.
The axis is made of stainless steel.
Two torsional spring safety returns lock in the original position.
The whole trigger consists of 20 parts. Tested on springs up to M190.
All spare parts available.
Easy to install in less than two minutes.
Allow the use of the stock safety lever.
The complete set is designed and assembled in the Czech Republic. Partial technical solutions are protected by copyright!
This high quality trigger set fits SW (Snow Wolf) M24 and also CYMA M24 (CM.702). You can use it for stock or for any custom upgrade piston and cylinder.
No comments entered for:
Similar Products
Similar Products
Similar Products
Similar Products
Similar Products
Similar Products