CUSTOM ADJUSTABLE TRIGGER AMOEBA EFCS BLACK PROMETHEUS (167545)
Excellent availability
Insert quantity
Fast shipping
Secure Payments
Certified transaction
Original products
Built for the Ares Amoeba EFCS series of rifles, this new custom trigger is highly adjustable and will significantly improve trigger response. Thanks to two independently positioned dowels, it is possible to adjust both the length or response of the trigger, and the travel / angle of the trigger. The stroke can be adjusted from the outside of the gearbox at any time, while the trigger adjustment is done when installing the trigger inside the gearbox.
This makes it a much easier method to adjust your shotgun trigger to your taste. In addition, the straight serrated trigger allows for maximum grip and quick semi-automatic firing.
Adjustment:
Headless Screw A: Adjusts the length / pull of the trigger.
Headless Screw B: Adjusts the travel / angle of the trigger.
1. To install and adjust the response and stroke lengths, first loosen the dowel A, then install it in the gearbox. Gradually adjust pin A to the desired trigger response between pin A and the trigger switch.
ATTENTION: Before completely reassembling the gearbox, check if the safety mechanism engages, if the trigger response is shortened too much, the safety will stop working.
2. After the rear derailleur has been reassembled and put back into the casing of your Ares Amoeba, adjust the knob B to adjust the angle / travel of the trigger. There is a small screw hole that can be accessed using an Allen key from the outside of the shifter while the shifter is installed.
CAUTION: Over-tightening of the dowel B can prevent the trigger from fully engaging or fully releasing the trigger switch.
This makes it a much easier method to adjust your shotgun trigger to your taste. In addition, the straight serrated trigger allows for maximum grip and quick semi-automatic firing.
Adjustment:
Headless Screw A: Adjusts the length / pull of the trigger.
Headless Screw B: Adjusts the travel / angle of the trigger.
1. To install and adjust the response and stroke lengths, first loosen the dowel A, then install it in the gearbox. Gradually adjust pin A to the desired trigger response between pin A and the trigger switch.
ATTENTION: Before completely reassembling the gearbox, check if the safety mechanism engages, if the trigger response is shortened too much, the safety will stop working.
2. After the rear derailleur has been reassembled and put back into the casing of your Ares Amoeba, adjust the knob B to adjust the angle / travel of the trigger. There is a small screw hole that can be accessed using an Allen key from the outside of the shifter while the shifter is installed.
CAUTION: Over-tightening of the dowel B can prevent the trigger from fully engaging or fully releasing the trigger switch.
No comments entered for:
Similar Products
Similar Products
Similar Products
Similar Products
Similar Products
Similar Products