CNC PISTON FOR DSG 8T RETRO ARMS (RA-9397)

A specially lengthened, reinforced and significantly lightened piston, designed for DSG groups.
The piston can be used in standard gearboxes, but is optimized for DSG retroarms gearboxes (6394).
This piston differs from the standard piston because it has a longer body and at the same time adjusted dimensions of the guides, ensuring less leverage during a short piston stroke.
This piston has a precise surface on the top for the ball bearings integrated into the DSG retroarms gearboxes.
The rear is significantly reinforced to withstand the forces created by the use of strong springs in the TSG, DSG and SS groupsets (reaching force often around 19kg) in combination with rapid load changes due to high cadences, often even 60 rps.
It is this combination and timing, along with the forces of the ordinary pistons, that cause the rear end of the piston to break off and shoot the piston rack into the rear end of the gearbox.
The piston body is made by CNC milling in nylon with the addition of 30% glass fibers. This material has excellent properties, in particular it is resistant to wear, survives high temperatures and pressures, tolerates the action of aggressive oils very well, is resistant to breakage and is also light.
The nylon material used is oil resistant and although it is not absolutely necessary to lubricate the piston body guide grooves, we have integrated lubrication pockets at the contact point between the piston and gearbox. Despite the robust and extended body, it was possible to keep the weight relatively low, which is very important for dsg, namely 15.2 g.
We do not recommend enlarging the drain holes due to possible damage to the structure.
The weight of the piston may vary due to moisture absorption of the material.
However, we strongly advise against drying the piston, immersion in moisture significantly increases the strength of the material.
The piston rack is made of high quality spring steel by CNC milling.
The material used is flexible and at the same time, thanks to the heat treatment, it is also hard, resistant to wear. Although it is not necessary to glue the piston rack, some customers glue it (in that case we recommend a two-component epoxy glue) and for this reason we leave the racks raw (without surface treatment that carries a layer of oil) after the heat treatment, so they are no longer black, but dark gray and may have various colored spots.
Before installation, it is recommended to lubricate the piston rack, ideally with silicone Vaseline.
This extended piston can also be used in combination with the extended dsg/tsg spring guide (6678), which prevents the spring from twisting and there is no risk of the front part of the piston breaking. This piston has 8 teeth and is therefore only suitable for use with tsg and dsg 8t gearboxes e.g. pandora (8008 or 8047).

Piston made by CNC
in nylon gf30%
for 8t dsg configurations
weight 12g