V3 MOSFET WITH JEFFTRON CABLES (JT-MOS-W4)

Professionally made mosfet for airsoft electric guns (AEG).
The device increases the gun's rate of fire and the battery lasts longer than the basic harness.
It is fully integrated into the version 3 gearbox in place of the original trigger contacts, compatible with the Tokyo Marui standard.

SPECIFICATIONS:
Mosfet is based on trigger contacts of the SHS company
Easy installation inside the version 3 reducer
Pre-welded cables allow for quicker and easier installation in the gun, it is long enough for all types of guns.
Just cut the cables to the required length and connect the connectors (included in the package)
2 high quality 1.5 qmm (AWG16) black wires with MPPE insulation, 400 mm length to the motor and 600 mm to the battery, are pre-soldered on the devices. The blue cable 0.34 qmm (AWG22) with a length of 1000 mm is used for connection at any point of the red cable
A 1000mm 1,5qmm (AWG16) red wire with MPPE insulation is included in the package
Board covered with protective coating, protects the device from water
If you want to use your own cables, choose the device without wiring
Designed for springs up to M160 (equivalent for 75A single shot current or 25A burst fire for max. 30 seconds). For a higher load please use Mosfet II (it is external to the gearbox)
Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
No power consumption in idle mode
No spark on the switch contacts
In automatic fire mode, the piston stops in a random position thanks to the mechabox design
For proper operation you must have a functional shift override lever, selector plate, reverse stop, trigger and trigger lock, as it has standard shifting

INSTRUCTIONS FOR THE DEVICE: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 761.42 KB]

PACKAGING:
mosfet on trigger contacts with wiring
trigger switch
Male DeanT connector
30A mini fuse
4x 2.8mm female faston
6x black heat shrink tube 3,2mm - length 20mm
3x black heat shrink tubing 4,8mm - length 20mm
English installation manual

ATTENTION: The installation of this device is entrusted to an expert, who could weld and disassemble the airsoft gun. Never use the welding gun!
We cannot guarantee 100% compatibility with all gearboxes, but Mosfet V3 will fit standard and common brand gearboxes without major modifications.