MOSFET V2 HYBRID FRONT CABLES PERUN (HB-V2-FW)

Adjustable trigger sensitivity : The trigger can be set to 5 sensitivity levels, ranging from a very short pull needed to fire a shot, to a very long one. No modification to the trigger or shifter is required, and changing the sensitivity of the trigger is also possible in the field.

Independently programmed firing modes - Program firing modes as you like, setting safe, semi, burst or automatic on either switch position.

Active brake : the active brake stops the engine after each shot, preventing spring compression or in case of replicas with high rate of fire, overspin (double hit problem).

Preload - Quick trigger response can be a matter of winning or losing, especially in CQB situations. With pre-arming enabled, the piston will remain in the retracted position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring after using the pre-arm, press the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without pre-arm and fully braked.

2-stage trigger : A light pull of the trigger is achieved with a single shot or burst, while a deeper pull will cause a burst or fully automatic fire. The following modes are available: semi - burst, semi - auto and burst - auto.

Binary Trigger - Allows for easy double hits in semi-automatic mode. After enabling this mode, if semi-automatic fire is set, the shots will be fired not only when the trigger is pulled, but also when it is released.

Rate of Fire Reduction - Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

DMR Mode - Introduces intervals between semi-automatic shots to comply with DMR rules on some fields.

Low Battery Voltage Alarm - Dedicated for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

DSG - a sector gear sensing mode specially prepared to work with dual sector gears.

Diagnostic System - Constantly monitors the replication and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.

Electronic fuse : it will save your replica and battery in case of a serious malfunction. It will automatically disconnect the battery when a short circuit or blocked motor is detected.

Programming of all settings is done exclusively using quick and easily memorable sequences of fire selector switching and trigger pulls supported by beeps and multi-colored LEDs. This allows you to change settings at any time, in seconds, even under enemy fire. All settings are set independently for each switch position, so you can program the mosfet exactly how you want, for example semi on semi and binary trigger on auto.

Perun V2 Hybrid works smoothly with any battery from 7V to 17V. It can also be used with most extreme configurations.

MANUAL