MOSFET II WITH JEFFTRON CABLES (JT-MOS-W2)

Professionally made mosfet for airsoft electric guns (AEG).
The device increases the gun's rate of fire and the battery lasts longer than the basic harness.

SPECIFICATIONS:
Very small device, it fits almost anywhere
Wireless devices, max. 1.5qmm (AWG16) power cables and 0.5qmm (AWG20) signal cables
Suitable for the service center, if you are not familiar with soldering to the printed circuit board, choose a device with wiring and accessories
Designed for springs up to M210 (equivalent for 150A single shot current or 50A burst fire for up to 30 seconds)
Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipo 7.4 - 14.8V)
6-wire connection

Device dimensions 25x12x7mm
No power consumption in idle mode
No spark on the switch contacts
In automatic fire mode, the piston stops in a random position thanks to the mechabox design
For proper operation you need to have a functional shift override lever, selector plate, reverse stop, trigger and trigger lock, as it has the standard shift

INSTRUCTIONS FOR THE DEVICE: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 685.43 KB]

PACKAGING: device, heat shrink tubing and installation manual in English

ATTENTION: The installation of this device is entrusted to an expert, who could weld and disassemble the airsoft gun. Never use the welding gun!