MOSFET FOR VECTOR KRYTAC PERUN (KV-XX-XX)

Freely programmable firing modes: set any firing mode you like to any of the selector positions independently. The available modes are: safe, semi, binary, 2 to 5 round burst and automatic.

Active brake : the active brake stops the engine after each shot, preventing spring compression or in case of replicas with high rate of fire, overspin (double hit problem).

Preload - Quick trigger response can be a matter of winning or losing, especially in CQB situations. With pre-arming enabled, the piston will remain in the retracted position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring after using preload, pull and hold the trigger. A second shot will be fired after 3 seconds, without pre-arming and fully braked.

Rate of Fire Reduction - Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

Low battery voltage alarm - Dedicated for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

Diagnostic System - Constantly monitors the replication and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.
Electronic fuse : it will save your replica and battery in case of a serious malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.

The programming of all the settings is done exclusively by means of a trigger and a selector, in sequences that can be easily memorized and quickly. Programming is supported by sound signals and multicolored LED diode. This allows you to change settings at any time, in seconds, even under enemy fire.

Perun for Krytac Kriss Vector works smoothly with any battery from 7V to 17V. It can be used even with the most extreme configurations, without any limitation regarding the evaluation of the spring.