MICRO MOSFET II WITH JEFFTRON CABLES (JT-MOS-W1)

Professionally made mosfet for airsoft electric guns (AEG).
The device increases the gun's rate of fire and the battery lasts longer than the basic harness.

SPECIFICATIONS:
Very small device, it fits almost anywhere
Wireless devices, max. 1.5qmm (AWG16) power cables and 0.5qmm (AWG20) signal cables
suitable for the service center, if you are not familiar with soldering to the printed circuit board, please choose a device with wiring and accessories.
Designed for springs up to M160 (equivalent for 75A single shot current or 25A burst fire for max. 30 seconds).
For a higher load please use Mosfet II
Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
5-wire connection
The positive lead is not connected to the device
device size 15x7x5mm
No power consumption in idle mode
No spark on the switch contacts
In automatic fire mode, the piston stops in a random position thanks to the mechabox design
A functional shift override lever, selector plate, reverse stop, trigger and trigger lock must be available for proper operation

INSTRUCTIONS FOR THE DEVICE: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 679.66 KB]

PACKAGING: device, heat shrink tubing and installation manual in English

ATTENTION: The installation of this device is entrusted to an expert, who could weld and disassemble the airsoft gun. Never use the welding gun!