AB ++ UNIVERSAL PERUN MOSFET (AB-XX-UW)

AB ++ is an on-wire mosfet, which conveys energy from the battery to the motor through a specialized high-power transistor, instead of delicate mechanical switches, increasing reliability and replication performance. Also improve your replication by adding many useful new features.

It comes with a universal harness, which can be used in any replica. Only a few simple solder joints are needed to install the mosfet.

Electronic Burst : Change your car into an electronically controlled burst to save ammo and increase realism!

Active brake : The active brake stops the engine after each shot, preventing the compression of the spring or in case of replicas with a high rate of fire, overspin (double hit problem).

Pre-armament : A quick trigger response can be a matter of victory or defeat, especially in CQB situations. With pre-arming enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring after using preload, pull the trigger while pressing the button on the unit. A shot will be fired, without pre-armament and fully braked.

Rate of Fire Reduction - Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

DMR Mode - Introduces intervals between semi-automatic shots to comply with DMR rules on some fields.

Low Battery Voltage Alarm - Dedicated for Li-Po and Li-Ion batteries. When the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

Diagnostic System - Constantly monitors the replication and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.

Electronic fuse : it will save your replica and battery in case of a serious malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.

The programming of all the settings takes place exclusively through the use of a trigger and a button on the device, in easily memorable and quick sequences. Programming is supported by sound signals and a multicolored LED diode. This allows you to change settings at any time, in seconds, even under enemy fire.

The upgrade kit works seamlessly with any 7V to 17V battery. It can be used even with the most extreme configurations, without any limitation regarding the evaluation of the spring.

MANUAL